Geplaatst op 7 Reacties

Colloidal Silver Generator (High Strength) FREE

Colloidal Silver Generator (High Strength) FREE


Vitaminstore.nl

De beste Nederlandse online gezondheidswinkel voor:

Veel mensen zoeken naar:

==>> Bezoek Vitaminstore.nl



 
I created this video using my Logitech webcam software. d


Vitaminstore.nl

De beste Nederlandse online gezondheidswinkel voor:

Veel mensen zoeken naar:

==>> Bezoek Vitaminstore.nl



 

7 gedachten over “Colloidal Silver Generator (High Strength) FREE

  1. your solution should be clear to slightly yellowish, your making silver nitrate then silver ions , shouldnt be gray

  2. where does the Nitrogen come from? so if you let it go too long it changes to ionic silver?

  3. Ive been making ionic silver for years , a few things can cause off gassing ,,from the cathode , too low of voltage and too high relative to amps ,, The volume of water used can affect premature off gassing if the solution isnt being stirred, also If the water has impurities , must be distilled . 26 – 30 volts from 3, 9 volt batteries in 10 oz of water works best for me , usually once you see off gassing the solution is saturated with silver ions and ready.

  4. I started with 3 9V and 8 oz of water. It turned yellow…but I wanted it stronger..I fell asleep..got a saturated solution for sure… using 4 9V batt. I made the coffe pot full in 5 min. but I just started and have to get a ppm tester/Thanks for your input.

  5. ppm meter is only good for testing silver ions if the solution is clear once its turned any colour , you can not differentiate between what is silver ions and off gassing , Glad to help anytime be well

  6. Here is a good tip on making your colloidal silver. Purchase yourself a small aquarium pump and during the process have the pump bubbling your water this makes a very small particle colloidal silver. And since you have this in a coffee decanter I am assuming you are also keeping your water warm during this process which also gives you smaller particles. Always use nothing but distilled water and pure .9999 silver wire. If you want you can speed the process up if you put a little of a previous batch of colloidal silver in your distilled water when you start your process. Do not add anything else to speed up the process.

  7. As someone mentioned below your water should be relatively clear. Yours looks very cloudy. Also when heating the water during the process a long with keeping the water agitated, will aid in keeping your water clear .

Geef een reactie

Het e-mailadres wordt niet gepubliceerd. Vereiste velden zijn gemarkeerd met *